Caliper Bracket

Brake Service Hardware · Vehicle-Specific Caliper Brackets · Forged S45C Steel

Forged S45C CNC Caliper Brackets

TTSPORT Forged S45C CNC Caliper Brackets are vehicle-specific brake service components that position the caliper correctly over the rotor. Forged S45C carbon steel, CNC-machined mounting faces, and application-matched geometry help support accurate caliper centering, stable pad sweep, and reliable brake hardware alignment.

Why the Bracket Matters

The caliper bracket controls caliper position, rotor offset, and pad sweep. If the bracket flexes, sits off-center, or places the caliper at the wrong radial or lateral offset, the brake system can develop inconsistent pedal feel, uneven pad contact, abnormal wear, vibration, or reduced braking performance.

This is not a universal adapter. Each bracket must match the vehicle knuckle, TTSPORT caliper mounting pattern, rotor diameter, rotor thickness, and hardware specification.

• Forged S45C carbon steel for rigidity and fatigue resistance
• CNC-machined mating faces for accurate caliper-to-rotor alignment
• Geometry matched to vehicle knuckle and TTSPORT caliper mounting pattern
• Designed for repeatable torque-down when paired with the correct hardware
• Protective surface finish for under-vehicle corrosion resistance

Specifications

No specifications beyond those listed are claimed. Exact dimensions, hardware type, and torque values are issued with the bracket part number for your specific application.

This product page describes caliper brackets only. Calipers, brake rotors, brake pads, brake hoses, brake fluid, rotor hats, and installation hardware are not included unless separately specified on the final order.

Fitment Requirements

• Vehicle knuckle mounting pattern must match the bracket design.
• Caliper mounting pattern must match the bracket radial or axial mount geometry.
• Rotor diameter and thickness must match the bracket offset and pad sweep.
• Rotor hat offset or one-piece rotor offset must be confirmed before installation.
• Wheel clearance must be checked after the caliper and bracket are installed.

Installation & Safety

• Inspect knuckle mounting faces for burrs, rust, paint buildup, and debris before fitting.
• Clean all mating surfaces so the bracket seats flat against the knuckle.
• Use the supplied or specified bolts only — do not reuse stretched, corroded, damaged, or unknown-history hardware.
• Torque fasteners in the specified sequence to the value listed for your application.
• Verify caliper centering over the rotor and even pad-to-rotor clearance.
• Check brake hose routing and wheel clearance at full steering lock and suspension travel.
• Re-check torque after the first heat cycle and during routine brake service intervals.

When to Replace or Reconfirm Brackets

• Replace if the bracket is bent, cracked, corroded at the mounting face, or damaged from impact.
• Replace if mounting threads, bolt seats, or locating surfaces are damaged.
• Reconfirm fitment when changing rotor diameter, rotor thickness, rotor hat offset, or caliper model.
• Reconfirm fitment after knuckle swaps, axle swaps, or custom suspension changes.
• Inspect bracket surfaces during every rotor or caliper service.

Confirm Fitment Before Ordering

Send your vehicle year, make, model, trim, axle position, current TTSPORT caliper model, rotor diameter, rotor thickness, rotor hat offset if applicable, and wheel offset if known. TTSPORT will confirm the correct bracket part number for your build before purchase.

Frequently Asked Questions